OSPF Configuration Commands 431
Tos 0 metric: 1
E type : 2
Forwarding Address: 0.0.0.0
Tag: 1
display ospf nexthop Syntax
display ospf [ process-id ] nexthop
View
Any view
Parameter
process-id: Process ID of OSPF. The command is applied to all current OSPF
processes if you do not specify a process ID.
Description
Use the display ospf nexthop command to view the information about the
next-hop.
Example
# Display the OSPF next-hop information.
<SW8800> display ospf nexthop
OSPF Process 1 with Router ID 1.1.1.1
Address Type Refcount Intf Addr Intf Name
---------------------------------------------------------------------
202.38.160.1 Direct 3 202.38.160.1 Vlan-interface2
202.38.160.2 Neighbor 1 202.38.160.1 Vlan-interface2
Tab le 61 Description of the fields of the display ospf lsdb ase command
Field Description
type Type of the LSA
ls id Link state ID of the LSA
adv rtr Router ID of the router originating the LSA
ls age Age of the LSA in seconds
len Length of the LSA
seq# Sequence number of the LSA
chksum Checksum of the LSA
Options Options of the LSA
Net mask Network mask
E type Type of external route
Forwarding Address Forwarding address
Tag Tag
Tab le 62 Description of the fields of the display ospf nexthop command
Field Description
Address Address of next hop
Type Type of next hop
Refcount Reference count of the next hop, i.e., number of routes using this address as the
next hop
Intf Addr IP address of the outgoing interface to the next hop
To Next Page
Loading...
