1022 CHAPTER 60: INFORMATION CENTER
Parameter
None
Description
Use the terminal debugging command to configure to display the debugging
information on the terminal.
Use the undo terminal debugging command to configure not to display the
debugging information on the terminal.
By default, the terminal display function of debugging information is disabled.
Related command: debugging.
Example
# Enable the terminal display debugging.
<SW8800> terminal debugging
terminal logging Syntax
terminal logging
undo terminal logging
View
User view
Parameter
None
Description
Use the terminal logging command to enable terminal log information display.
Use the undo terminal logging command to disable terminal log information
display.
By default, the log information display is enabled on the console and disabled on
the terminal.
Example
# Disable the terminal display function of log information.
<SW8800> undo terminal logging
terminal monitor Syntax
terminal monitor
undo terminal monitor
View
User view
To Next Page
Loading...
