3Com 8807 - Display Protocol-Vlan Interface

84 CHAPTER 4: VLAN CONFIGURATION COMMANDS
Note that you can add/delete trunk port and hybrid port to/from VLAN by the port
and undo port commands in Ethernet port view, but not in VLAN view.
Related command: display vlan.
Example
# Add Ethernet2/1/1 through Ethernet2/1/3 to VLAN 2.
[3Com-vlan2] port ethernet2/1/1 to ethernet2/1/3
Protocol-Based VLAN
Configuration
Commands
display protocol-vlan
interface
Syntax
display protocol-vlan interface { interface-list | all }
View
Any view
Parameter
interface-list: Displays the protocol information of a specified interface, in the form
of interface-list = { interface-type interface-number [ to interface-type
interface-number ] }. interface-type is interface type, interface-number is interface
number. The interface number after the keyword to must be larger than or equal
to the interface number before to.
all: Displays the protocol information of all ports.
Description
Use the display protocol-vlan interface command to view the protocol
information and protocol index configured on the specific port, to which you can
refer when you use the protocol-based VLAN and add/delete a protocol.
Related command: display interface.
Example
# Display the protocol information and protocol index configured on
Ethernet2/1/1.
<SW8800> display protocol-vlan interface ethernet2/1/1
Interface: Ethernet2/1/1
Vlan-ID Index Type Value
10 0 at
10 1 ethernetii etype 0x0600
10 2 llc dsap 0x01 ssap 0x02
10 3 snap etype 0x0700
10 4 ipx ethernetii
10 5 ipx llc
10 6 ipx raw
10 7 ipx snap