778 CHAPTER 42: VPLS CONFIGURATION COMMANDS
display vsi Syntax
display vsi vsi-name
View
Any view
Parameter
vsi-name: VSI name.
Description
Use the display vsi command to display the information of one specific or all VSIs.
Related command: vsi.
Example
# Display the configuration of VSI 3Com.
<SW8800> display vsi 3Com
VPLS-Instance : 3Com
VSI service status : Open
Vsi ID : 1000
Vpn ID : 54
MTU : 900
Description : 3Com Corporation Co., Ltd.
VPLS Peers : 2
3.3.3.3 1000 npe
4.4.4.4 1000 npe
Interface :
Vlan-interface1000
Bandwidth: 20480kbps
Broadcast-restrain: 10%
CoS : 8
CoS-table : [2 0 1 3 4 5 6 7]
Mac-table limit : 128
MTU Specifies the MTU of the VSI
Status VSI service status: open (enabled) or shutdown (closed)
VCID Virtual circuit ID
EncapType Encapsulation type
PeerAddr IP address of peer PE
Lcl-Label Local label, namely, label that the local device assigns the peer PE.
Rmt-Label Remote label, namely, label that the remote PE assigns the local device.
TnlType Tunnel type, such as LSP
TnlID Tunnel ID
Table 98 Brief description on the fields of a VC
Field Description
Tabl e 99 Detailed description on the fields of a VC
Field Description
npe The peer PE is an NPE (network side PE).
Interface Interface bound to the VSI
To Next Page
Loading...
