MSTP Configuration Commands 177
Example
# Map VLAN 2 to MSTI 1.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800]stp region-configuration
[3Com-mst-region] instance 1 vlan 2
# Map VLAN5-10 to MSTI 3.
[3Com-mst-region] instance 3 vlan 5 6 7 8 9 10
region-name Syntax
region-name name
undo region-name
View
MST region view
Parameter
name: Specifies the MST region name of the switch with a character string not
exceeding 32 bytes.
Description
Use the region-name command to configure the MST region name of a switch.
Use the undo region-name command to restore the default MST region name.
By default, the MST region name of the switch is the switch MAC address in
hexadecimal notation.
The switch region name, together with VLAN mapping table of the MST region
and MSTP revision level, is used for determining the region to which the switch
belongs.
Related command: instance, revision-level, check region-configuration,
vlan-mapping modulo, active region-configuration.
Example
# Set the MST region name of the switch as abcde.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800]stp region-configuration
[3Com-mst-region] region-name abcde
reset stp Syntax
reset stp [ interface interface-list ]
View
User view
To Next Page
Loading...
