3Com 8807 - Igmp Proxy

616 CHAPTER 35: IGMP CONFIGURATION COMMANDS
<SW8800> reset igmp group interface Vlan-interface10 225.1.1.0 255.2
55.255.0
IGMP Proxy
Configuration
Commands
igmp proxy Syntax
igmp proxy interface-type interface-number
undo igmp proxy
View
Interface view
Parameter
interface-type: Proxy interface type.
interface-number: Proxy interface number.
Description
Use the igmp proxy command to enable IGMP proxy for the VLAN interface and
specify the IGMP proxy interface of the VLAN interface.
Use the undo igmp proxy command to remove IGMP proxy configuration.
By default, IGMP proxy is disabled on the interface.
c
CAUTION:
■ You need to enable PIM protocol for a VLAN interface before executing the
igmp proxy command in its VLAN interface view.
■ If you configure the IGMP proxy interface for a VLAN interface multiple times,
the latest configured IGMP proxy interface will take effect.
■ A VLAN interface cannot be the IGMP proxy interface for two or more other
VLAN interfaces simultaneously.
Example
# Enable IGMP proxy for the interface of VLAN 100 and specify the interface of
VLAN 200 to be its IGMP proxy interface.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] interface vlan-interface 100
[3Com-vlan-interface100] igmp proxy vlan-interface 200