3Com 8807 - Peer Allow-As-Loop; Peer As-Path-Acl Export

MBGP Multicast Extension Configuration Commands 667
Use the undo peer advertise-community command to remove the
configuration.
By default, no community attribute is sent to any peer group.
Example
# Set to send community attributes to peer group "test".
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
[3Com-bgp] ipv4-family multicast
[3Com-bgp-af-mul] peer test advertise-community
peer allow-as-loop Syntax
peer { group-name | peer-address } allow-as-loop [ number ]
undo peer { group-name | peer-address } allow-as-loop
View
IPv4 multicast sub-address family view
Parameter
group-name: Name of the peer group.
peer-address: IP address of the peer.
number: Repetition number of local AS IDs, in the range of 1 to 10. By default ,the
repetition number is 3.
Description
Use the peer allow-as-loop command to specify repetition number of local AS
IDs.
Use the undo peer allow-as-loop command to remove the configuration.
Related command: display current-configuration, display bgp routing-table
peer and display bgp routing-table group.
Example
# Configure repetition number of local AS IDs as 2.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
[3Com-bgp] ipv4-family multicast
[3Com-bgp-af-mul] peer 1.1.1.1 allow-as-loop 2
peer as-path-acl export Syntax
peer { group-name | peer-address } as-path-acl acl-number export
undo peer { group-name | peer-address } as-path-acl acl-number export