3Com 8807 - Reset Dhcp Server Conflict; Reset Dhcp Server Ip-In-Use

DHCP Server Configuration Commands 847
Use the undo option command to remove a custom DHCP option configured for
the global DHCP address pool.
If you execute the option command multiple times, the new configurations
overwrite the corresponding old ones
Related command: dhcp server ip-pool, dhcp server option.
Example
# Configure a custom option for the global DHCP address pool, with an option
value of 100 and two hexadecimal numbers of 0x11 and 0x22.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] dhcp server ip-pool 0
[3Com-dhcp-0] option 100 hex 11 22
reset dhcp server
conflict
Syntax
reset dhcp server conflict { ip ip-address | all }
View
User view
Parameter
ip-address: Clears statistics about the specified IP address conflicts.
all: Clears all statistics about address conflicts.
Description
Use the reset dhcp server conflict command to clear statistics information about
DHCP address conflicts.
Related command: display dhcp server conflict.
Example
# Clear all statistics information about DHCP address conflicts.
<SW8800> reset dhcp server conflict all
reset dhcp server
ip-in-use
Syntax
reset dhcp server ip-in-use{ all | interface [ vlan-interface vlan-id ] | ip
ip-address | pool [ pool-name ] }
View
User view
Parameter
all: Specifies all binding entries.
ip-address: Specifies the binding entry that contains the specified IP address.