530 CHAPTER 27: BGP CONFIGURATION COMMANDS
Description
Use the peer filter-policy import command to configure the filter-policy list of
the routes received by a peer/peer group.
Use the undo peer filter-policy import command to cancel the existing
configuration.
By default, a peer/peer group has no access control list (acl).
Related command: ip as-path-acl, peer as-path-acl export, peer as-path-acl
import.
The priority of the inbound filter policy configured for the peer is higher than that
configured for the peer group.
Example
# Configure to use acl 2000 to filter the routes received by the peer group test..
[3Com-bgp] peer test filter-policy 2000 import
peer graceful-restart Syntax
peer { peer-address | group-name } graceful-restart
undo peer { peer-address | group-name } graceful-restart
View
BGP view
Parameter
group-name: Name of the peer group, which can consist of 1 to 47 alphabetic
letters and numerals.
peer-address: IP address of the peer.
Description
Use the peer graceful-restart command to enable the Graceful-restart ability of
the specified peer or peer group.
Use the undo peer graceful-restart command to disable the Graceful-restart
ability of the specified peer or peer group.
If the Graceful-restart ability is enabled for a peer group first, peers added into this
group afterwards also inherits the Graceful-restart ability of this group.
It is allowed that peers in a peer group have a different Graceful-restart ability than
that configured for this peer group. For example, after configuring Graceful-restart
for the whole peer group, you can disable the Graceful-restart ability of a specific
peer. To do so, you must configure Graceful-restart for the peer group first, and
then use the undo graceful-restart command on the peer.
Example
# Enable Graceful-restart on a peer whose IP address is 10.2.2.2.
To Next Page
Loading...
