OSPF Configuration Commands 443
Description
Use the import-route-limit command to set the maximum number of exterior
routes allowed to be imported.
Use the undo import-route command to restore the default value of the
maximum of exterior routes allowed to be imported.
By default, a maximum of 20K exterior routes are allowed to be imported.
Example
# Set the maximum number of exterior routes allowed to be imported to 50K.
[3Com-ospf-1] import-route-limit 50000
log-peer-change Syntax
log-peer-change
undo log-peer-change
View
OSPF view
Parameter
None
Description
Use the log-peer-change command to enable the switch for reporting the OSPF
peer changes.
Use the undo log-peer-change command to disable the switch for reporting the
OSPF peer changes.
The switch for reporting the OSPF peer changes is disabled by default.
Example
# Enable the switch for reporting the OSPF peer changes.
<SW8800> system-view
[SW8800] ospf
[3Com-ospf-1] log-peer-change
network Syntax
network ip-address ip-mask
undo network ip-address ip-mask
View
OSPF Area view
Parameter
ip-address: Address of the network segment where the interface resides.
To Next Page
Loading...
