QoS Commands 243
Example
# Display all the QoS parameter configurations of all the VLANs.
<SW8800> display qos-vlan all
Vlan 1 traffic-limit
Inbound:
There is no configuration.
Outbound:
There is no configuration.
Vlan 1 traffic-priority
Inbound:
There is no configuration.
Outbound:
There is no configuration
Vlan 1 traffic-redirect
Inbound:
There is no configuration.
Outbound:
There is no configuration
Vlan 1 traffic-statistic
Inbound:
There is no configuration.
Outbound:
There is no configuration.
Vlan 2 traffic-limit
Inbound:
Matches: Acl 2000 rule 1 running (Action-type: Eacl, Destination slot: 3)
Committed Information Rate: 8192 Kbps
Committed Burst Size: 10000 byte(s)
Excess Burst Size: 20000 byte(s)
Peak Information Rate: 0 Kbps
Exceed action: drop
Outbound:
There is no configuration
Vlan 2 traffic-priority
Inbound:
Matches: Acl 2000 rule 1 running (Action-type: Eacl, Destination slot: 3)
Priority action: remark-policed-service, untrusted, dscp: 13, cos: 6,
Local
-precedence: 6, drop-priority: 1
Outbound:
There is no configuration
Vlan 2 traffic-redirect
Inbound:
Matches: Acl 2000 rule 1 running (Action-type: Eacl, Destination slot: 3)
Redirected to: next-hop 1.1.1.1
Outbound:
There is no configuration
Vlan 2 traffic-statistic
Inbound:
There is no configuration.
Outbound:
There is no configuration.
---- More ----
display qos-vlan
traffic-limit
Syntax
display qos-vlan [ vlan-id ] traffic-limit
View
Any view
Parameter
vlan-id: ID of a VLAN, in the range of 1 to 4094.
To Next Page
Loading...
