Display Commands of the Routing Table 383
For detailed description of the output information, see Table 48.
# Display the verbose information of the Active and Inactive routes that are filtered
through basic acl 2000.
<SW8800> display ip routing-table acl 2000 verbose
Routes matched by access-list 2000:
+ = Active Route, - = Last Active, # = Both * = Next hop in use
Summary count: 2
**Destination: 10.1.1.0 Mask: 255.255.255.0
Protocol: #DIRECT Preference: 0
*NextHop: 10.1.1.2 Interface: 10.1.1.2(Vlan-interface1)
Vlinkindex: 0
State: <Int ActiveU Retain Unicast>
Age: 7:24 Cost: 0/0 Tag: 0
**Destination: 10.1.1.2 Mask: 255.255.255.255
Protocol: #DIRECT Preference: 0
*NextHop: 127.0.0.1 Interface: 127.0.0.1(InLoopBack0)
Vlinkindex: 0
State: <NoAdvise Int ActiveU Retain Gateway Unicast>
Age: 7:24 Cost: 0/0 Tag: 0
Tab le 49 Description of the fields of the display ip routing-table acl verbose command
Field Description
Destination Destination address
Mask Mask
Protocol Routing protocol
Preference Routing preference
Nexthop Next hop address
Interface Output interface, through which the data packet destined for the destination
network segment is sent
Vlinkindex Virtual link index
To Next Page
Loading...
