Logging in to Switch Commands 65
Example
# Configure to use commands level 0 after logging in from VTY 0 user interface.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] user-interface vty 0
[3Com-ui-vty0] user privilege level 0
# After you telnet from VTY 0 user interface to the switch, you will view the
terminal only displays commands at level 0.
<SW8800> ?
User view commands:
debugging Enable system debugging functions
language-mode Specify the language environment
ping Ping function
quit Exit from current command view
super Privilege current user a specified priority level
telnet Establish one TELNET connection
tracert Trace route function
undo Cancel current setting
To Next Page
Loading...
