3Com 8807 - Page 717

LDP Configuration Commands 715
# Display MPLS L3VPN ingress lsp information on PE (Provider Edge).
<SW8800> display mpls l3vpn-lsp ingress
-------------------------------------------------------------------
LSP Information: L3vpn Ingress Lsp
-------------------------------------------------------------------
Vpn-instance Name: vpna Route Distinguisher: 100:1
NO FEC NEXTHOP OUTER-LABEL OUT-INTERFACE
1 168.3.1.0/24 10.10.1.1 1026(vpn) Vlan10
TOTAL: 1 Record(s) Found.
# Display MPLS L3VPN egress lsp information on PE.
<SW8800> display mpls l3vpn-lsp egress
---------------------- -------------------------------------------
LSP Information: L3vpn Egress Lsp
-------------------------------------------------------------------
NO VRFNAME INNER-LABEL NEXTHOP OUT-INTERFACE
1 vpna 4096 0.0.0.0 InLoop0
TOTAL: 1 Record(s) Found.
I/O-LABEL Incoming/Outgoing label. VPN labels (labels advertised with VPNV4
routes) will be displayed in case of uni-hop EBGP cross-AS MPLS L3 VPN
networking, and tunneling labels (labels advertised with unicast routes
and labels advertised by LDP protocol) will be displayed in case of
multi-hop EBGP cross-AS MPLS L3 VPN networking.
NEXTHOP Next hop
IN-INTERFACE Ingress interface
OUT-INTERFACE Egress interface
Tab le 95 Description on the fields of the command
Field Description
NO Number
FEC Forwarding equivalent class
NEXTHOP Next hop
OUTER-LABEL Outer label (MPLS Tunneling Label)
OUT-INTERFACE Egress interface
Tab le 96 Description on the fields of the command
Field Description
NO Number
VRFNAME Name of VPN Instance
INNER-LABEL Inner label (VPN label)
NEXTHOP Next hop
OUT-INTERFACE Egress interface
Table 94 Description on the fields of the command
Field Description