12 Disturbance Analyzer Measurement
Sweep Control
Key Path
Sweep/ Control
Remote Command
:INITiate:IMMediate
:INITiate:RESTart
Example INIT:IMM
INIT:REST
Initial S/W Revision A.14.00
Start Analysis
Executes the disturbance analysis process and the measurement results will be shown after completion.
Key Path
Sweep/ Control
Remote Command
:INITiate:DANalyzer:SANalysis
Example INIT:DAN:SAN
Dependencies This key is grayed out when a measurement is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a “–221, Settings conflict” warning.
Initial S/W Revision A.12.00
1122 EMI Receiver Mode Reference
To Next Page
Loading...
