6 System Functions
System
Query the Mechanical Relay Cycle Count
Return the count of mechanical relay cycles. For N9038A model, there are additional 2 Mechanical Relays
which are <N9038A Input2>, <N9038A Bypass>.
Remote Command
:SYSTem:MRELay:COUNt?
Example :SYST:MREL:COUN?
Notes Query Only
The return value is a comma separated list of the individual counts for each mechanical relay.
The position of the relays in the list is:
“<Cal Signal>,<AC/DC>,<2dB #1 Atten>,<2dB #2 Atten>,<6dB Atten>,<10dB Atten>,<20dB
Atten>,<30dB Atten>,<Fixed Atten>,<Low Noise Path Switch>,<Presel Bypass>,<N9038A Input2>,
<N9038A Bypass>”
Items in the list not pertaining to your particular hardware configuration will return as –999 for those
items.
Initial S/W Revision Prior to A.02.00
Modified at S/W Revision A.08.00
Query the Operating Temperature Extremes
Returns the low operating temperature extreme value. The value survives a power-cycle and is the
temperature extreme encountered since the value was reset by the factory or service center.
Mode All
Remote Command
:SYSTem:TEMPerature:LEXTreme?
Example :SYST:TEMP:LEXT?
Notes Value is in degrees Celsius at which the lowest operating temperature has been recorded since 1st
power-up.
State Saved No
Initial S/W Revision Prior to A.02.00
Mode All
Remote Command
:SYSTem:TEMPerature:HEXTreme?
Example :SYST:TEMP:HEXT?
Notes Value is in degrees Celsius at which the highest operating temperature has been recorded since 1st
power-up.
State Saved No
Initial S/W Revision Prior to A.02.00
Query the Elapsed Time since 1
st
power on
Returns the elapsed on-time in minutes since 1st power-on.
EMI Receiver Mode Reference 351
To Next Page
Loading...
Need help?
General
