8 Frequency Scan Measurement
Marker To
Remote Command
:CALCulate:FSCan:SLISt:APPend:METer
Example
CALC:FSC:SLIS:APP:MET Append signal obtained at meters into signal list.
Notes If there is no free space in the signal list, the following prompt message will ask you whether to
continue or not: WARNING! There is not enough free space in Signal List. Would you like to clear the
Signal list before adding signals? Press ENTER to continue or ESC to Cancel.
Couplings The appended signal will be the selected signal after a Metersà List is performed.
Initial S/W Revision A.07.00
Snap to Meters (Select Closest Signal)
Changes the selected signal to the closest signal in the Signal List to where the meters frequency is tuned.
Key Path
Marker To
Remote Command
:CALCulate:FSCan:SLISt:SNAP:METers
Example
CALC:FSC:SLIS:SNAP:MET
Notes
If there are two signals with equal frequency difference found, the signal with lower frequency will be
selected.
If the signal list contains no data, an error is generated and this function cannot be performed.
Initial S/W Revision A.07.00
426 EMI Receiver Mode Reference
To Next Page
Loading...
Need help?
General
