10 Monitor Spectrum Measurement
Meas Setup
Clear All
Clears all the marks from the signal list.
Key Path
Meas Setup, Signal List, Mark Signals
Remote Command
:CALCulate:SLISt:MARK:CLEar:ALL
Example CALC:SLIS:MARK:CLE:ALL Clear mark from all signals.
Notes If the signal list contains no data, an error is generated and this function cannot be performed.
Initial S/W Revision A.13.00
Delete Signals
This key opens the delete signals option menu.
Key Path
Meas Setup, Signal List
Initial S/W Revision A.13.00
Select Signal
Specifies the selected signal. The term “Selected signal” is used throughout this document to specify
which signal will be affected by the functions.
Key Path
Meas Setup, Signal List, Delete Signals
Notes Front panel only.
Dependencies Yes
Couplings When the signal list is cleared, this value will reset to 0.
Preset If the signal list is empty, =0
If the signal list is not empty, = number of peaks in signal list table
State Saved Saved in instrument state
Min 0
Max Number of peaks in signal list table.
Initial S/W Revision A.13.00
Delete Signal
Deletes the selected signal. If you accessed this function from the front panel, the following message will
prompt you for confirmation to delete the selected signal from the signal list.
This will delete the selected signal. Are you sure you want to do this?
Please press Enter or OK to proceed. Press ESC or Cancel to close this dialog.
784 EMI Receiver Mode Reference
To Next Page
Loading...
Need help?
General
