8 Frequency Scan Measurement
Meas
Meas
The information in this section is common to all measurements. For key and remote command information
for a specific measurement, refer to the section that describes the measurement of interest.
Measurements available under the Meas key are specific to the current Mode.
When viewing Help for measurements, note the following:
Operation for some keys differs between measurements. The information displayed in Help pertains to the
current measurement. To see how a key operates in a different measurement, exit Help (press the Cancel
Esc key), select the measurement, then reenter Help (press the Help key) and press that key.
Key Path
Front-panel key
Initial S/W Revision Prior to A.02.00
Remote Measurement Functions
This section contains the following topics:
"Measurement Group of Commands" on page 1048
"Current Measurement Query (Remote Command Only) " on page 1050
"Limit Test Current Results (Remote Command Only)" on page 1050
"Data Query (Remote Command Only)" on page 1050
"Calculate/Compress Trace Data Query (Remote Command Only)" on page 1051
"Calculate Peaks of Trace Data (Remote Command Only)" on page 1056
Hardware-Accelerated Fast Power Measurement (Remote Command Only)
"Format Data: Numeric Data (Remote Command Only)" on page 1057
"Format Data: Byte Order (Remote Command Only)" on page 1058
Initial S/W Revision Prior to A.02.00
EMI Receiver Mode Reference 427
To Next Page
Loading...
Need help?
General
