Keysight PXA X Series User Manual

3 Programming the Analyzer
STATus Subsystem
Questionable Calibration Skipped Negative Transition
This command determines which bits in the Questionable Calibration Skipped Condition register will set
the corresponding bit in the Questionable Calibration Skipped Event register when the condition register bit
has a negative transition (1 to 0). The variable <integer> is the sum of the decimal values of the bits that
you want to enable.
Mode All
Remote Command
:STATus:QUEStionable:CALibration:SKIPped:NTRansition <integer>
:STATus:QUEStionable:CALibration:SKIPped:NTRansition?
Example STAT:QUES:CAL:SKIP:NTR 1 Align RF skipped is not required.
Preset 0
Min 0
Max 32767
Status Bits/OPC
dependencies
Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Skipped Positive Transition
This command determines which bits in the Questionable Calibration Skipped Condition register will set
the corresponding bit in the Questionable Calibration Skipped Event register when the condition register bit
has a positive transition (0 to 1). The variable <integer> is the sum of the decimal values of the bits that you
want to enable.
Mode All
Remote Command
:STATus:QUEStionable:CALibration:SKIPped:PTRansition <integer>
:STATus:QUEStionable:CALibration:SKIPped:PTRansition?
Example STAT:QUES:CAL:SKIP:PTR 1 Align RF skipped is required.
Preset 32767
Min 0
Max 32767
Status Bits/OPC
dependencies
Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Extended Failure Register
"Questionable Calibration Extended Failure Condition " on page 121
"Questionable Calibration Extended Failure Enable " on page 121
"Questionable Calibration Extended Failure Event Query " on page 121
"Questionable Calibration Extended Failure Negative Transition " on page 122
120 EMI Receiver Mode Reference

Keysight PXA X Series Specifications

General

Brand	Keysight
Model	PXA X Series
Category	Measuring Instruments
Language	English