3 Programming the Analyzer
STATus Subsystem
Mode All
Remote Command
:STATus:QUEStionable:CALibration:EXTended:FAILure[:EVENt]?
Example STAT:QUES:CAL:EXT:FAIL?
Preset 0
Status Bits/OPC
dependencies
Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Extended Failure Negative Transition
This command determines which bits in the Questionable Calibration Extended Failure Condition register
will set the corresponding bit in the Questionable Calibration Extended Failure Event register when the
condition register bit has a negative transition (1 to 0). The variable <integer> is the sum of the decimal
values of the bits that you want to enable.
Mode All
Remote Command
:STATus:QUEStionable:CALibration:EXTended:FAILure:NTRansition <integer>
:STATus:QUEStionable:CALibration:EXTended:FAILure:NTRansition?
Example STAT:QUES:CAL:EXT:FAIL:NTR 1 EMI conducted align failure is not required.
Preset 0
Min 0
Max 32767
Status Bits/OPC
dependencies
Sequential command
Initial S/W Revision Prior to A.02.00
Questionable Calibration Extended Failure Positive Transition
This command determines which bits in the Questionable Calibration Extended Failure Condition register
will set the corresponding bit in the Questionable Calibration Extended Failure Event register when the
condition register bit has a positive transition (0 to 1). The variable <integer> is the sum of the decimal
values of the bits that you want to enable.
Mode All
Remote Command
:STATus:QUEStionable:CALibration:EXTended:FAILure:PTRansition <integer>
:STATus:QUEStionable:CALibration:EXTended:FAILure:PTRansition?
Example STAT:QUES:CAL:EXT:FAIL:PTR 1 EMI conducted align failure is required.
Preset 32767
Min 0
Max 32767
122 EMI Receiver Mode Reference
To Next Page
Loading...
