8 Frequency Scan Measurement
Meas Setup
they are added solely for remote language compatibility.
Dependencies This function is not available when a scan sequence is running. If the SCPI command is sent, the
message is generated as part of a “–221, Settings conflict” warning.
Couplings When 0, all ranges will be turned off.
Preset 1
Min 0
Max 10
Backwards
Compatibility SCPI
SENSe1|SENSe2:SCAN:RANGes[:COUNt]
Initial S/W Revision A.07.00
Final Measurement (Remote Command Only)
This command performs a Final Measurement for all signals in the peak list.
Remote Command
INITiate[1]|2:FMEasurement
Example
INIT:FME
Notes This command above is included for ESU compatibility. The suffix [1]|2 is irrelevant to the
measurement, they are added solely for remote language compatibility.
This command is alias to :FSC:SEQ:REM ALL; :FSC:SEQ REM; :INIT.
Dependencies This key is grayed out when a scan sequence is running. If the grayed out key is pressed, an advisory
message is generated. If the equivalent SCPI command is sent, this same message is generated as
part of a “–221, Settings conflict” warning.
Initial S/W Revision A.07.00
Search Method (Remote Command Only)
This command defines the search method with which maxima are searched for within a scan.
Remote Command
CALCulate[1]|2:PEAKsearch|PSEarch:METHod SUBRange|PEAK
CALCulate[1]|2:PEAKsearch|PSEarch:METHod
Example CALC:PEAK:METH SUBR Selects subrange method.
Notes SUBRange aliases to:FSCan:SEARch:MODE SLIM; CALC:FSC:MARK:PEAK:SEAR:MODE MAX, which
actually set Search Criteria = “Subrange and Limits” and Peak Criteria = “Highest Peak”.
PEAK aliases to :FSCan:SEARch:MODE PLIM; CALC:FSC:MARK:PEAK:SEAR:MODE MAX;
FSC:SEAR:PEAK:COUN:STAT OFF, which actually set Search Criteria = “Peak Criteria and Limits”,
Peak Criteria = “Highest Peak” and # of Peaks State = ON.
Initial S/W Revision A.11.00
508 EMI Receiver Mode Reference
To Next Page
Loading...
Need help?
General
