Lenze i550

11.2.2 Analog input 2
Sengs for analog input 2.
Intended use
The analogue input 2 can be used for the following tasks:
•
As a standard setpoint source
Intended use Parameter Seng Further informaon
As a setpoint source for specifying
a frequency setpoint.
0x2860:001
(P201.01)
Analog input 1
[3]
Frequency control 4Standard setpoint source ^ 82
As setpoint source for dening the
reference value for the process
controller.
0x2860:002
(P201.02)
Analog input 1
[3]
Frequency control 4Conguring the process controller ^ 116
As a setpoint source for dening a
torque setpoint.
0x2860:003
(P201.03)
Analog input 1
[3]
Torque control4Standard setpoint source ^ 151
As an alternave to the seng as a standard setpoint source, the "Acvate AI2 setpoint" 0x2631:015 (P400.15) funcon can be used to enable a
setpoint change-over to the analogue input 2.
•
As an actual value source or speed feedforward source for the process controller:
Intended use Parameter Seng Further informaon
As an actual value source for the
process controller.
0x4020:002
(P600.02)
Analog input 2
[2]
Frequency control 4Conguring the process controller ^ 116
As a speed feedforward source for
the process controller.
0x4020:004
(P600.04)
Analog input 2
[3]
Details
The following sengs are possible for the analog input:
•
Denion of the input range
①
•
Filter me for low-pass lters
②
•
Monitoring of the input signal
③
•
Dead band for eliminang the smallest signal levels
④
•
Denion of the seng range
⑤
AI2
0x2637:0020x2637:0080x2637:001
%
Hz
0x2637:006
0x2637:0030x2637:009
0x2637:010
0x2637:007
0x2637:004
0x2637:005
X3
%
V/mA
0x2DA5:002
0x2DA5:003
x y
<
>
0x2860:001
0x2860:002
[Hz]
[PID unit]
0x2637:011
0x2637:012
%
%
0x2DA5:004
0x2860:003
[%]
%
PID
unit
Analog input 2 [3]
Torque setpoint source
Analog input 2 [3]
Process controller setpoint source
Frequency setpoint source
Analog input 2 [3]
Diagnosc parameters:
•
The frequency value is displayed in 0x2DA5:002 (P111.02).
•
The process controller value is displayed in 0x2DA5:003 (P111.03).
•
The torque value is displayed in 0x2DA5:004 (P111.04).
For further details and conguraon examples, see chapter "Analog input 1". ^ 255
I/O extensions and control connecons
Congure analog inputs
Analog input 2
260