RM0091 General-purpose I/Os (GPIO)
Doc ID 018940 Rev 1 129/742
8.4.5 GPIO port input data register (GPIOx_IDR) (x = A..D, F)
Address offset: 0x10
Reset value: 0x0000 XXXX (where X means undefined)
8.4.6 GPIO port output data register (GPIOx_ODR) (x = A..D, F)
Address offset: 0x14
Reset value: 0x0000 0000
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res.
1514131211109876543210
IDR15 IDR14 IDR13 IDR12 IDR11 IDR10 IDR9 IDR8 IDR7 IDR6 IDR5 IDR4 IDR3 IDR2 IDR1 IDR0
rrrrrrr r r r rrrrrr
Bits 31:16 Reserved, must be kept at reset value.
Bits 15:0 IDR[15:0]: Port input data
These bits are read-only. They contain the input value of the corresponding I/O port.
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res. Res.
1514131211109876543210
ODR15 ODR14 ODR13 ODR12 ODR11 ODR10 ODR9 ODR8 ODR7 ODR6 ODR5 ODR4 ODR3 ODR2 ODR1 ODR0
rw rw rw rw rw rw rw rw rw rw rw rw rw rw rw rw
Bits 31:16 Reserved, must be kept at reset value.
Bits 15:0 ODR[15:0]: Port output data
These bits can be read and written by software.
Note: For atomic bit set/reset, the ODR bits can be individually set and reset by writing to the
GPIOx_BSRR register (x = A..D, F).
To Next Page
Loading...
Need help?
General
