Comparator (COMP) RM0091
220/742 Doc ID 018940 Rev 1
Bit 23 WNDWEN: Window mode enable
This bit connects the non-inverting input of COMP2 to COMP1’s non-inverting input,
which is simultaneously disconnected from PA3.
0 : Window mode disabled
1 : Window mode enabled
Bits 22:20 COMP2INSEL[2:0]: Comparator 2 inverting input selection
These bits allows to select the source connected to the inverting input of the
comparator 2.
000: 1/4 of Vrefint
001: 1/2 of Vrefint
010: 3/4 of Vrefint
011: Vrefint
100: COMP2_INM4 (PA4 or DAC if enabled)
101: COMP2_INM5 (PA5)
110: COMP2_INM6 (PA2)
111: Reserved
Bits 19:18 COMP2MODE[1:0]: Comparator 2 mode
These bits control the operating mode of the comparator2 and allows to adjust the
speed/consumption.
00: High speed
01: Medium speed
10: Low power
11: Ultra-low power
Bit 17 Reserved, must be kept at reset value.
Bit 16 COMP2EN: Comparator 2 enable
This bit switches ON/OFF the comparator2.
0 : Comparator 2 disabled
1 : Comparator 2 enabled
Bit 15 COMP1LOCK: Comparator 1 lock
This bit is write-once. It is set by software. It can only be cleared by a system reset.
It allows to have all control bits of comparator 1 as read-only.
0 : COMP_CSR[15:0] bits are read-write.
1 : COMP_CSR[15:0] bits are read-only.
Bit 14 COMP1OUT: Comparator 1 output
This read-only bit is a copy of comparator 1 output state.
0 : Output is low (non-inverting input below inverting input).
1 : Output is high (non-inverting input above inverting input).
Bits 13:12 COMP1HYST[1:0] Comparator 1 hysteresis
These bits are controlling the hysteresis level.
00: No hysteresis
01: Low hysteresis
10: Medium hysteresis
11: High hysteresis
Please refer to the electrical characteristics for the hysteresis values.
Bit 11 COMP1POL: Comparator 1 output polarity
This bit is used to invert the comparator 1 output.
0 : output is not inverted
1 : output is inverted
To Next Page
Loading...
Need help?
General
