8 Implements ISOBUS for implements
off) and when application of the material actually starts or stops.
Tap... To...
On Latency
Enter the length of time (seconds) from when a section is turned
on to when the system begins to apply material.
Off Latency
Enter the length of time (seconds) from when a section is turned
off to when the system stops applying material.
Apply Latency to
Boundary
Turn setting on or off by tapping. This setting applies to fields
that have a boundary, and when you exit an exclusion zone and
return to the workable area of the field.
On: The system uses on latency to begin applying material
immediately when crossing a boundary.
Off: The system starts when the boundary is reached and any
mechanical delay could leave a gap between the boundary and
where the product is applied. When GPS accuracy is low, this is
the preferred selection.
Sections Off when
Stopped
Turn setting on or off:
On: The sections shut down when the vehicle is stopped.
Off: The sections remain open (turned on) when the vehicle is
stopped.
e.
At OVERLAPS enter the appropriate settings for section control and tap Next.
Tap... To...
Start Overlap Enter the amount of overlap (distance) you want when starting
coverage.
When you are in a previously covered area driving toward an
non-covered area, the system will begin turning sections on at
this distance before reaching the non-covered area.
End Overlap
Enter the amount of overlap (distance) you want when stopping
coverage.
When you are applying material and driving toward a previously
covered area, the system will keep sections on until they are this
far into the previously covered area.
194 TMX-2050 Display User Guide Version 1.075, Revision C
To Next Page
Loading...
