Trimble TMX-2050 - Page 193

ISOBUS for implements 8 Implements
Tap... To...
Material Type Select the material you will be applying:
ll Anhydrous
l Granular Fertilizer
l Granular Seed
l Liquid
l Row Crop Seed
ISOImplement Data Select the ECU of the implement you are using to assign this ECUto
this channel.
Note – This is required before you can use this channel.
12.
At the SETTINGSscreen, tap to turn on:
a. Rate Control to use rate control. There is no need to complete any other settings because
the ECU provides this information.
b.
Rate Snapping to use rate snapping.This setting smooths out rate fluctuations seen on the
screen.
Setting Explanation
Off The display shows instant readings from the feedback sensor. This may
show frequent minor rate fluctuations.
On The display smooths out the values. You will see the target rate as the
applied rate whenever the applied rate is within 10% of the target rate.
c. Section Control if you want to use section control.
13. If you chose to use section control:
a. While still at the SETTINGS screen, tap Number of Sections. The ECUsends this
information to the system.Verify the number of sections and tap Next.
b. At the WIDTH screen the system shows the number of sections you indicated in the
previous screen and the width of each section. This information is obtained from the ECU.
c. Tap Next to continue to LATENCIES.
d.
At LATENCIES, enter the applicable settings for section control and tap Next.
Latency refers to the delay between when the command occurs (to turn a section on or
Version 1.075, Revision C TMX-2050 Display User Guide 193