April 2017
2-94
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
012-295, 012-296, 012-300
Launch Issue
Status Indicator RAPs
Enter dC330 code 012-045 and 012-042 alternately. The stapler move motor runs.
YN
Check the wiring between P/J8981 pins 13 to 16 on the finisher PWB and P/J8888 on
the stapler move motor for an open or short circuit, or loose or damaged connectors.
The
wiring is good.
YN
Reconnect or repair as necessary.
Install a new staple move motor assembly, PL 13.20 Item 9. If the fault persists, install a
new finisher PWB, PL 13.45 Item 2.
Check for an intermittent connection. If the check is good, install a new stapler assembly, PL
13.20 Item 4. If the fault persists, install a new finisher PWB, PL 13.45 Item 2.
012-300 Eject Cover Open RAP
BSD-ON: BSD 13.3 Office Finisher LX Interlock Switching
012-300 Eject cover switch open was detected.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Ensure that the eject cover, PL 13.25 Item 1 is closed.
• Check the eject cover switch, PL 13.27 Item 19 for improper installation.
• Check eject cover switch connectors for connection failure.
• Check the switch actuator for damage.
Procedure
Enter dC330 code 012-300. Actuate the eject cover switch. The display changes
YN
Check the wiring between J8889 pin 1 and 2 for an open or short circuit, or loose or dam-
aged connectors. The wiring is good.
YN
Install a new eject cover switch, PL 13.27 Item 19.
Check the wiring between J8889 on the eject cover switch and J8982 on the finisher for
an open or short circuit, or loose or damaged connectors. If the check is good, install a
new finisher PWB, PL 13.45 Item 2.
The wiring is good.
YN
Reconnect or repair as necessary.
Install a new finisher PWB, PL 13.45 Item 2.
Install a new finisher PWB, PL 13.45 Item 2.
A
To Next Page
Loading...
Need help?
General
