April 2017
2-140
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
016-515, 016-516
Launch Issue
Status Indicator RAPs
016-515 XPS Short of Memory
016-515 During XPS Bridge processing, a lack of memory was detected.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Advise the customer to check the print mode. If print mode is set to High Resolution,
change it to Standard. If print mode is set to Standard, change it to High Speed.
2. Ensure that all connectors on the ESS PWB, PL 3.10 Item 6 and hard disk, PL 3.10 Item
2 are securely connected. Ensure all surface mounted modules are securely connected.
3. Reload the software, GP 4.
4. If the fault persists, perform the 016A Scan to Network Error Entry RAP.
016-516 XPS Print Ticket Description Error RAP
016-516 XPS Print Ticket description error.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Advise the customer to check whether the application that sends a print job and the print
instructions has a problem.
2. Ensure that all connectors on the ESS PWB, PL 3.10 Item 6 and hard disk, PL 3.10 Item
2 are securely connected. Ensure all surface mounted modules are securely connected.
3. Reload the software, GP 4.
To Next Page
Loading...
Need help?
General
