Xerox WorkCentre 3615 Service Manual

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-350
Precautions and Limitations
The following describes the precautions and limitations for TCP/IP (LPD).
Machine Settings
• IP Addresses are managed in a whole system. Consult with the Network Administrator
thoroughly before perform setting.
• Depending on the network environment, perform the sub net mask and gateway
settings if necessary. Consult with the Network Administrator to set necessary settings.
• If a memory becomes insufficient when Enabled is set for the port status, the port status
may be automatically reset to Disabled. In this case, set Disabled for unused ports or
change the memory allocated capacity.
• Depending on the usage environment, set the receiving buffer capacity lpd (Spool) size.
When the receiving buffer capacity lpd (Spool) size is smaller than the sent data, it may
not be able to be received.
Computer Settings
• IP Addresses are managed in a whole system. Consult with the Network Administrator
thoroughly before perform setting.
• To perform network settings (such as IP Address), etc. on the host used under NIS
(Network Information Service) management, consult with the NIS Administrator.
At Power OFF
Before turning the machine OFF, take note of the following:
• When Memory is set for lpd (Spool)
All the print data including the data being printed that have been spooled in the
machine memory will be deleted. When the power is turned ON again, no print data
remains.
However, if the power is turned OFF immediately after the print instruction, the print
data may be stored on the computer. In this case, even if a new print instruction is issued
after the power is turned ON, the stored print data will be printed first.
• When Hard Disk is set for lpd (Spool)
All the print data including the data being printed that have been spooled in the
machine hard disk will be saved. When the power is turned ON again and a new print
instruction is issued, the stored print data will be printed first.
• When No Spooling is set for lpd (Spool)
All the print data including the data being printed that have been spooled in the
machine receiving buffer will be deleted. When the power is turned ON again, no print
data remains.
However, if the power is turned OFF immediately after the print instruction, the print
data may be stored on the computer. In this case, even if a new print instruction is issued
after the power is turned ON, the stored print data will be printed first.

Xerox WorkCentre 3615 Specifications

General

Print Technology	Laser
Print Resolution	Up to 1200 x 1200 dpi
Fax	Yes
Duplex Printing	Yes
Functions	Print, Copy, Scan, Fax
Processor	533 MHz
Memory (Standard)	256 MB
Paper Output	250 sheets
Fax Speed	33.6 kbps
Print Speed	47 ppm
Scan Resolution	600 x 600 dpi
Automatic Document Feeder	50 sheets
Connectivity	Ethernet
First Page Out Time (Copy)	8.5 seconds
Paper Capacity	250 sheets
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac, Linux