Instructions for use Zeus Infinity Empowered SW 2.n 281
Fault – Cause – Remedy
Warning 100 Infusion line 3
blocked
Occlusion at line 3 detected.
Pressure limit reached. Infu-
sion 3 stopped.
Check infusion line 3 and
connection to the patient.
Increase pressure alarm
limit. Restart infusion 3.
Caution 100 Infusion line 3
blocked?
The line 3 pressure in-
creased rapidly. Pressure
alarm limit is nearly reached.
Check infusion line and
connection to the patient.
Increase pressure alarm
limit, if necessary.
Warning 100 Infusion line 4
blocked
Occlusion at line 4 detected.
Pressure limit reached. Infu-
sion 4 stopped.
Check infusion line 4 and
connection to the patient.
Increase pressure alarm
limit. Restart infusion 4.
Caution 100 Infusion line 4
blocked?
The line 4 pressure in-
creased rapidly. Pressure
alarm limit is nearly reached.
Check infusion line and
connection to the patient.
Increase pressure alarm
limit, if necessary.
Note 100 Infusion running Infusion is still runnig. Re-
mote control and alarm dis-
play of the IV system is ter-
minated.
Control infusion rate at the
pump. Return to operating
mode to remote control the
pumps.
Caution 100 Infusion system fail Infusion system failed. Press reset button, if sys-
tem reboot is desired. Sys-
tem will not be available for
some minutes!
Caution 119 Insp. CO
2 high Upper limit of insp. CO2-
concentration exceeded for
2 breath. cycles. Soda lime
exhausted.
Increase fresh gas flow! Ex-
change soda lime!
Caution 255 Insp. desflurane
high
Insp. vol. agent higher than
alarm limit for 30 sec.
Check volatile agent deliv-
ery setting! Check fresh gas
flow!
Caution 255 Insp. desflurane
high
Insp. vol. agent mixture
higher than 3 xMAC.
Check DIVA settings and
fresh gas flow.
Classifi-
cation
Pri-
ority
Alarm text Cause Remedy
To Next Page
Loading...
