11 APD Measurement
Save
update. After saving to a file, the analyzer automatically returns to the previous menu and any Save
As dialog goes away.
Backwards
Compatibility SCPI
:MMEMory:STORe:STATe 1,<filename>
For backwards compatibility, the above syntax is supported. The "1" is simply ignored. The
command is sequential.
Initial S/W Revision Prior to A.02.00
To File . . .
When you press “To File”, the analyzer brings up a Windows dialog and a menu entitled “Save As.” This
menu allows you to navigate to the various fields in the Windows dialog without using a keyboard or
mouse. The Tab and Arrow keys can also be used for dialog navigation.
The Listed below
are the functions of the various fields in the dialog, and the corresponding softkeys:
Save
Performs the save to the specified file of the selected type. If the file already exists, a dialog will appear
that allows you to replace the existing file by selecting OK, or you can Cancel the request. If you select OK,
the file will be overwritten. Using the C: drive is strongly discouraged, since it runs the risk of being
overwritten during an instrument software upgrade.
While the save is being performed, the floppy icon appears briefly in the Meas bar.
982 EMI Receiver Mode Reference
To Next Page
Loading...
Need help?
General
