OPERATION
Adjusting Reel Speed “On The Go”
Figure 4 .298: Operator Console
A-Displ
ay
B-Heade
r I ndex
C - Auger Fast D - Auger S low
E - Reel Fast
F - Reel Slow G - Display Selector
The reel speed adjustment range is from 15 to 85 rpm. Adjust the reel speed while the machine is in operation
as follows:
1. Set HEADER INDEX switch (B) to OFF.
2. Press REEL SLOW (F) or REEL FAST (E) on the ground s peed lever (GSL) until display (A) shows ##.##
REEL RPM with desired reel speed.
The displayed value (##.##) = reel speed (rpm or mph or km/h
26
).
NOTE:
Adjust
ing reel speed will alter auger speed unless the auger speed has been preset.
SettingReeltoGroundSpeed
Setting the speed of the reel relative to ground speed (using the header index function) automatically adjusts the
reel speed with changes to ground speed. Benefits may include improved crop flow and reduced operator fatigue.
Setting the reel to ground speed requires setting the minimum reel speed and the reel index.
26. Depending on CDM programming.
147649 297 Revision A
To Next Page
Loading...
