NEC Univerge SV8100 - Package Network Setup

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 81
Description
Use Program 10-55: Package Network Setup to set the network settings for each
installed blade. This program sets the SPOE of each package.
Program 10 : System Configuration Setup
10-55 : Package Network Setup
Level:
IN
Input Data
Slot Number 1~24
Input Data
Item
No.
Item Input Data Default
01
IP Address
0.0.0.0~126.255.255.254
128.0.0.1~191.255.255.254
192.0.0.1~223.255.255.254
172.16.1.100
02
LAN Setup
LAN setup for
each unit
0 = Auto Detect
1 = 100Mbps, Full Duplex
2 = 100Mbps, Half Duplex
3 = 10Mbps, Full Duplex
4 = 10Mbps, Half Duplex
0
03
Main/Add-on
1 unit will
automatically set
as Main (1)
0=Main
1 = Add-on
1
04
Sub Net Mask
128.0.0.0 192.0.0.0 224.0.0.0
240.0.0.0 248.0.0.0 252.0.0.0
254.0.0.0 255.0.0.0 255.128.0.0
255.192.0.0 255.224.0.0 255.240.0.0
255.248.0.0 255.252.0.0 255.254.0.0
255.255.0.0 255.255.128.0 255.255.192.0
255.255.224.0 255.255.240.0
255.255.248.0 255.255.252.0
255.255.254.0 255.255.255.0
255.255.255.128 255.255.255.192
255.255.255.224 255.255.255.240
255.255.255.248 255.255.255.252
255.255.255.254 255.255.255.255
255.255.0.0