UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 63
Description
(This program is aviable for V7000 or higher for AU)
Use Program 10-41: General Purpose Contact Detector Setup to specify the
circuit number used on a PGD Adapter as a contact detection circuit.
Conditions
None
Feature Cross Reference
Analog Communications Interface (ACI)
Program 10 : System Configuration Setup
10-41: General Purpose Contact Detector Setup
Level:
IN
Input Data
General Purpose Contact Detector Number 1-8
Item
No.
Item Input Data Default
01
System ID
The user can set System ID when the Link is
active
0: Not Using the NetLink
1 - 50: System ID
0
Slot Number
Define the slot number of the DLC to which the
PGD Adapter is connected
0 = No Setting
1-24 = Slots 1-24
0
02
Physical Port Number
Select the port number on the DLC to which
the PGD Adapter is connected.
0 = No Setting
1-16 = Ports 1-16
0
03
Relay Circuit Number
Select the relay circuit on the PGD Adapter
module.
0 = No Setting
1-2 = Circuit Number 1-2
0
To Next Page
Loading...
