NEC Univerge SV8100 - Service Code Setup (for System Administrator)

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 105
Description
Use Program 11-10: Service Code Setup (for System Administrator) to customize the
Service Codes for the System Administrator. You can customize additional Service
Codes in Programs 11-11~11-16. The following chart shows:
 The number of each code (01~42).
 The function of the Service Code.
 The type of telephones that can use the Service Code.
 The default entry. For example, dialing item 26 allows users to force a trunk line to
disconnect.
Program 11 : System Numbering
11-10 : Service Code Setup (for System Administrator)
Level:
IN
Input Data
Item
No.
Item Terminals
Default
(OT)
Default
(AU)
Related
Program
01
Night Mode Switching
MLT, SLT 818 718 12-xx
20-07-01
02
Change of music on hold tone
(OT)
MLT 881 - 10-04
03
Setting the System Time
MLT 828 728
04
Storing Common Speed Dialing
Numbers
MLT 853 753
05
Storing Group Speed Dialing
Numbers
MLT 854 754
06
Setting the Automatic Transfer
for Each Trunk Line
MLT 833 733 24-04-01
07
Canceling the Automatic
Transfer for Each Trunk Line
MLT 834 734 24-04-01
08
Setting the Destination for
Automatic Trunk Transfer
MLT 835 735 24-04-01
09
Charging Cost Display by the
Supervisor
MLT 771 No Setting
10
--- Not Used ---
11
Entry Credit for Toll Restriction
MLT 774 No Setting