NEC Univerge SV8100 - 84-27: IPL Basic Setup

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 831
Description
Use Program 84-27: IPL Basic Setup to set the DTMF Relay and the SRTP mode of
the IPL.
Program 84 : Hardware Setup for VoIP
84-27: IPL Basic Setup
Level:
IN
Index 1
Slot Number 1
Input Data
Item
No.
Item Input Data Default
01
DTMF Relay Setup
0 = DTMF Relay disabled
1 = In-Band DTMF Relay – Do
not report to host processor
2 = Out of Band Relay – Do not
pass tones as voice
2
02
Setup CODEC Mode
Default means the system uses another
CODEC except G.723.
Mode 1 means the system uses all
CODECs, but the limitation of the total
number of available DSP will be applied.
0 = Default
1 = Mode 1 (G.723/iLBC)
0
03
SRTP Mode Setup
IPLB doesn’t have a limitation of the total
number of available channels, even if
you set to 1.
0 = Disable
1 = Enable
0
04
SRTP Mode Select
0 = Mode1
0
06
H.245 Port Number
0~65535
10100
07
Preparation Completion Response
Port Number
0~65535
4000
08
DTMF Duration (In Band)
Used only by IPLB. Effective when
84-27-01 = 1 (In Band).
0: follow RFC2833
25~2000(ms)
0
09
DTMF Pause
Used only by IPLB. Effective when
84-27-01 = 1 (In Band).
0: follow RFC2833
25~2000(ms)
0