NEC Univerge SV8100 - 84-32: FAX over IP CODEC Setup

Issue 10.1 UNIVERGE SV8100
2 - 844 Program 84 : Hardware Setup for VoIP
Description
Use Program 84-32: FAX Over IP CODEC Setup to program the CODECs used
when faxing across CCISoIP networks. Note these settings must match in both
systems for faxing across CCISoIP to work.
Program 84 : Hardware Setup for VoIP
84-32: FAX Over IP CODEC Setup
Level:
IN
Input Data
Type 1 = CCIS over
2 = SIP Trunk
3 = Not Used
4 = Not Used
Input Data
Item
No.
Item Input Data Default
01
FAX CODEC
Set up FAX over IP CODEC
Settings when using CCIS over IP.
If set to 4 [T.38 (UDPTL)], system
does not follow PRG 84-32-02~07.
1 = G.711 a-law
2 = G.711 u-law
3 = G.726
4 = T.38 (UDPTL)
1
02
Payload Size
Set up payload size when using
CCIS over IP.
1~4 (10ms base)
2
03
Jitter Buffer Mode
Set up Jitter Buffer settings when
using CCIS over IP.
1 = Static
2 = Self adjusting
1
04
Jitter Buffer (min)
Set up minimum Jitter Buffer
settings when using CCIS over IP.
0~300
20
05
Jitter Buffer (average)
Set up average Jitter Buffer
settings when using CCIS over IP.
0~300
40
06
Jitter Buffer (max)
Set up maximum Jitter Buffer
settings when using CCIS over IP.
0~300
80