NEC Univerge SV8100 - SIP Server Information Setup

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 49
Description
Use Program 10-29 : SIP Server Information Setup to define the SIP Proxy setup
for outbound/inbound. The 10-29 commands are not used in non-registration mode.

If entries are made in Program 10-29-xx for a SIP Server and the SIP Server is then removed or
not used, the entries in Program 10-29-xx must be set back to their default settings. Even if
10-29-01 is set to 0 (off), the SV8100 still checks the settings in the remaining 10-29 programs.
Program 10 : System Configuration Setup
10-29 : SIP Server Information Setup
Level:
SA
Input Data
Item
No.
Item Input Data Default
01
Default Proxy (Outbound)
This sets whether the SIP message is
always sent through the Default Proxy.
0 = Off
1 = On
0
02
Default Proxy (Inbound)
Need to be registered in registration mode.
This sets whether the SIP message is
always received through the Default Proxy.
0 = Off
1 = On
0
03
Default Proxy IP Address
This is optional and used if the provider
gives you a proxy address that is different
than the registration address. If the
provider is using domain names instead of
IP addresses, leave this at default.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0
04
Default Proxy Port Number
The port number of the Default Proxy is set.
0 ~ 65535
5060
05
Registrar Mode
The mode registered in the registration
server is set.
0 = None
1 = Manual
0
06
Registrar IP Address
IP address of the SIP registration server is
set.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0
07
Registrar Port Number
The port number of the SIP registration
server is set.
0 ~ 65535
5060