NEC Univerge SV8100 - 85-04: Port Mirroring Setup (AU)

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 853
Description
Use Program 85-04: Port Mirroring Setup to define the port mirroring for each ETIA
blade. This permits traffic from one port to be simultaneously transmitted to a second
port. Port mirroring is typically used for debugging with a protocol analyzer.
Conditions
 Set to the port where the protocol analyzer is connected.
Feature Cross Reference
 Voice Over Internet Protocol (VoIP)
Program 85 : Hardware Setup for ETIA Switch
85-04: Port Mirroring Setup (AU)
Level:
IN
Input Data
Hub Slot 1~24
Item
No.
Item Input Data Default Description
01
Port Mirroring
0 = Disable
1 = Enable
0
02
Source Port
1~8
1 Set to the port to be monitored.
03
Target Port
1~8
1 Set to the port where the protocol analyzer
is connected.