NEC Univerge SV8100 - 41-19: ACD Voice Mail Delay Announcement

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 507
Description
Use Program 41-19: ACD Voice Mail Delay Announcement to assign IPK II In-Mail
Master Mailboxes (PRG 47-03) as ACD Delay “Announcement” Mailboxes.
Program 41 : ACD Setup
41-19: ACD Voice Mail Delay Announcement
Level:
SA
Input Data
ACD Group Number 1 ~ 64
Item
No.
Item Input Data Default
01
Delay Message Start Timer
Determines how long the system waits before playing the
Delay Message.
0 ~ 64800 (sec)
0
02
Mailbox Number for 1st Announcement Message
Assigns the Voice Mail ACD Announcement Mailbox as
the message source for the 1st Announcement Message.
Dial
(up to eight digits)
No Setting
03
1st Delay Message Sending Count
Determines the 1st Delay Message Sending Count. This
entry must be set to 1 or higher for the message to play.
0 = No message is
played.
0 ~ 255
0
04
Mailbox Number for 2nd Announcement Message
Assigns the Voice Mail ACD Announcement Mailboxes as
the message source for the 2nd Announcement Message.
Dial
(up to eight digits)
No Setting
05
2nd Delay Message Sending Count
Determines the 2nd Delay Message Sending Count. This
entry must be set to 1 or higher for the message to play.
0 = No message is
played.
0~ 255
0
06
Wait Tone Type at Message Interval
Determines what the caller hears between the messages.
0 = Ring Back
Tone
1 = Music On Hold
Tone
2 = Background
Music Source
0
07
ACD Forced Disconnect Time after 2nd
Announcement
Assigns how long the system should wait after the end of
the ACD Delay Message before disconnecting.
0 ~ 64800 (sec)
0