NEC Univerge SV8100 - Programming; SECTION 2 START-UP PROGRAMMING (DEFAULT)

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 343
Description
Use Program 22-02: Incoming Call Trunk Setup to assign the incoming trunk type
for each trunk. There is one item for each Night Service Mode.
Conditions
 When connecting to T1 trunks, after changing Program 22-02-01 to match the
Telco connected T1 service type, the T1 cable or the T1 blade must be unplugged
and then reconnected for the T1 blade to sync.
 When the trunk type is set to 3 (DID), the DID Transfer to Destination in 22-11-04
for each DID feature is not supported. This feature is supported only for DID
trunks when assigned as VRS.
 When the trunk type is set to 3 (DID), the DID Intercept Destination feature for
each DID is not supported. This feature is supported only for DID trunks assigned
as VRS.
Program 22 : Incoming Call Setup
22-02: Incoming Call Trunk Setup
Level:
IN
Input Data
Trunk Port Number 001~200
Day/Night Mode 1~8
Item
No.
Item Input Data Default Description
Related
Program
01
Incoming
Type
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2=DISA
3=DID
4=DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
0
Use this option to set the
feature type for the trunk
you are programming.
14-04