NEC Univerge SV8100 - DTMF and Dial Tone Circuit Setup

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 23
Description
Use Program 10-09: DTMF and Dial Tone Circuit Setup to allocate the circuits on
the CD-CP00 for either DTMF receiving or dial tone detection. The CD-CP00 has 32
circuits initially, and an additional 64 circuits are added when a PZ-BS10 is installed.
These are used as follows:
 Extension DTMF receiver for single line telephone
 Trunk DTMF receiver for analog trunks, dial tone & busy tone detection
for analog trunks
Conditions
 CD-CP00 has 32 channel DSP resources (receivers) only for basic chassis. PZ-
BS10 have 64 DSP resources (receivers) only for expand chassis.
 In case of 0 (= Common) is selected, and if 14-02-10 (Caller ID receive ability) is
set to “Yes”, DSP resources are always allocated to analog trunk only, not for
analog extension. If 14-02-10 is set to “No”, the DSP resources can be used for
both analog trunk and analog extension commonly.
Program 10 : System Configuration Setup
10-09 : DTMF and Dial Tone Circuit Setup
Level:
IN
Input Data
Circuit/Resource Number 01~160
Item
No.
Input Data Default Setting
01 0 = Common Use
1 = Extension Only
2 = Trunk Only
Circuit/Resource 01~08 = 1 (Extensions)
Circuit/Resource 09~32 = 2 (Trunks)
(Circuit/Resource 33~96 are not used.)
Circuit/Resource 97~160 = 0 (Common)
When PZ-BS10 is installed, 97~160 are available.