UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 645
Description
Use Program 51-03 : NetLink Internet Protocol Address List Setting to set the IP
address of the NetLink system.
Conditions
The system seeks Primary system based on this list.
When there is no Primary System yet, or Fail Over occurs, Node List is referred to
establish new link.
This setting is necessary when PRG 51-01-03 is 0, or PRG 51-05-02 is other than
0. Once the system connects to the Primary System, this setting is updated by the
Primary system when PRG 51-13-01 is on. So, enter IP address of the systems
which may become Primary at least.
Program 51 : NetLink Service
51-03 : NetLink Internet Protocol Address List Setting
Level:
IN
Input Data
List ID 1~50
Item
No.
Item Input Data Default
01
Internet Protocol Address List
The system seeks the Primary system based on
this list.
When there is no Primary system yet, or Fail
Over occurs, Node List is referred to establish
new link. This setting is necessary when PRG
51-01-03 is 0, or PRG 51-05-02 is other than 0.
Once the system connects to the Primary
System, this setting is updated by the Primary
system when PRG 51-13-01 is On. So, enter IP
address of the systems which may become
Primary at least.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0
To Next Page
Loading...
