NEC Univerge SV8100 - How to Enter Programming Mode

Issue 10.1 UNIVERGE SV8100
1 - 2 Introduction
The reverse type (white on black) just beneath the Description heading is the program
access level. You can only use the program if your access level meets or exceeds the
level the program requires. Refer to Section 3 How to Enter Programming Mode on
page 1-2 for a list of the system access levels and passwords.
Feature Cross Reference provides you with a table of all the features affected by the
program. You will want to keep the referenced features in mind when you change a
program. Customizing a feature may have an effect on another feature that you did
not intend.
Telephone Programming Instructions shows how to enter the program data into
system memory. For example:
1. Enter the programming mode.
2. 15-07-01
tells you to enter the programming mode, dial 150701 from the telephone dial
pad. After you do, you will see the message “15-07-01 TEL” on the first line of
the telephone display. This indicates the program number (15-07), item number
(01), and that the options are being set for the extension. The second row of the
display “KY01 =
01” indicates that Key 01 is being programmed with the entry
of
01. The third row allows you to move the cursor to the left or right,
depending on which arrow is pressed. To learn how to enter the programming
mode, refer to Section 3 How to Enter Programming Mode below.
SECTION 3 HOW TO ENTER PROGRAMMING MODE
To enter programming mode:
1. Go to any working display telephone.
 In a newly installed system, use extension (port 1).
2. Do not lift the handset.
3. Press Speaker.
4.
#  #  .
5. Dial the system password + Transfer.
Refer to the following table for the default system passwords. To change the
passwords, use 90-02: Programming Password Setup.
15-07-01 TEL
KY01 = *01

Password