NEC Univerge SV8100 - Page 27

UNIVERGE SV8100 Issue 10.1
Programming Manual 1 - 3
SECTION 4 HOW TO EXIT PROGRAMMING MODE
To-exit the programming mode:
When you are done programming, you must be out of a program option to exit
(pressing the Answer key will exit the program option).
1. Press Answer key to exit the program options, if needed.
2. Press Speaker. If changes were made to the system programming, “Saving
System Data” is displayed.
3. The display shows "Complete Data Save" when completed and exits the
telephone to an idle mode.
 To save a customer’s database, a blank USB Drive is required. Insert the USB Drive into
the CD-CP00 and, using Program 90-03, save the software to the USB Drive. (Program
90-04 is used to reload the customer data if necessary.) Note that a USB Drive can only
hold one customer database. Each database to be saved requires a separate drive.
Password
User
Name
Level Programs at this Level
******** nec-i 1(MF)
Manufacture Level (MF)
20-12(AU),40-04(AU), 40-07, 80-02(OT), 80-11(OT), 81-
04, 81-05, 82-01(AU), 82-03(AU), 82-04(AU), 82-05, 82-08
12345678 tech 2 (IN)
Installation (IN):
All programs in this section not listed for MF, SA, & SB
0000 ADMIN1 3 (SA)
System Administrator – Level 1 (SA):
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17,
10-18, 10-23, 10-24, 10-25, 10-27(OT), 10-28, 10-29, 12-
02, 12-03, 12-04, 12-08, 15-01, 15-07, 15-09, 15-10, 15-
11, 20-16, 20-34 21-07, 21-14, 22-04, 22-11, 22-17, 25-08,
30-03, 30-04, 32-02, 41-02, 41-03, 41-04, 41-05, 41-06,
41-07, 41-08, 41-09, 41-10, 41-11, 41-12, 41-13, 41-14,
41-15, 41-16, 41-17, 41-18, 41-19, 41-20, 45-02, 84-22,
90-03, 90-04, 90-06, 90-07, 90-19, 90-57, 90-58, 90-59,
90-65
9999 ADMIN2 4 (SB)
System Administrator – Level 2 (SB):
13-04, 13-05, 15-14
Program Mode
Base Service OP1 OP2