NEC Univerge SV8100 - 34-11: E1 Trunk Basic Setup (OT)

UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 465
Description
Use Program 34-11: E1 Trunk Basic Setup to define the basic setting of each E1
Trunk.
Program 34 : Tie Line Setup
34-11: E1 Trunk Basic Setup (OT)
Level:
IN
Input Data
Trunk Port Number 1~200
Item
No.
Name Input Data Default
01
E1 Trunk Type
Use this option to specify the
E1Signal type(0-8). Set this option
for compatibility with the
connected telco.
0 = Standard Trunk
1 = Argentine Pulsed Clear Back Trunk
2 = Argentine Pulsed Answer Trunk
3 = Brazil With seizure acknowledge
Trunk
4 = Brazil Without seizure acknowledge
Trunk
5 = Brazil E&M Signal A(Idle=0) Trunk
6 = Brazil E&M Signal A(Idle=1) Trunk
7 = Brazil E&M Signal B(Idle=0) Trunk
8 = Brazil Code for collect call blocking
Trunk
0
02
MFC Dialing Type
Use this option to specify the MFC
Dialing Type. The following table
shows the available MFC Dialing
Type choices, By default, this
option is 0 (MFC Dialing not used).
0 = MFC Dialing not used
1 = NEC Standard
2 = Argentina
3 = Brazil
4 = Chile
5 = Colombia
6 = Mexico
7= Venezuela
0
03
MFC Group B
Use this option to enable(1) or
disable(0) the MFC Dialing Group
B supervisory signaling. Since not
all central offices provide Group B
signaling, set this option for
compatibility with the connected
telco. By default, this option is
Disable(0).
0 = Disable
1 = Enable
0