UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 777
Description
Use Program 84-11 : D
term
IP CODEC Information Basic Setup to set voice (RTP
packet) encoding parameters.
Program 84 : Hardware Setup for VoIP
84-11 : D
term ®
IP CODEC Information Basic Setup
Level:
IN
Input Data
Type 1 = Type 1
2 = Type 2
3 = Type 3
4 = Type 4
5 = Type 5
Item
No.
Item Input Data Default
01
Number of G.711 Audio Frame
Maximum number of G711 Audio Frames.
When the voice is encoded using the PCM
(Pulse Code Modulation) method, a unit is a
frame of 10ms.
1 = 10 ms
2 = 20 ms
3 = 30 ms
4 = 40 ms
3
02
G.711 Silence Detection (VAD) Mode
Select whether to compress silence with
G.711. When there is silence, the RTP packet
is not sent.
0 = Disable
1=Enable
0
03
G.711 Type
Set the type of G.711.
0=A-law
1=
µ-law
0
04
G.711 Jitter Buffer - Minimum
Set the minimum value of the G.711 Jitter
Buffer.
Moreover, this option is adjusted with the
SV8100 as it is used by both IP terminals and
the IPLA and the range of the adjustment of
Jitter for the IP terminal is narrower and
transmitted to the IP terminal. The range of IP
terminal is 10-300 (10).
0~255ms (Note 2)
30
To Next Page
Loading...
