UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 185
Description
Use Program 15-03 : Single Line Telephone Basic Data Setup to set up various
single line telephone options.
Program 15 : Extension, Basic Setup
15-03 : Single Line Telephone Basic Data Setup
Level:
IN
Input Data
Extension Number Maximum eight digits
Item
No
Item Input Data Default
Related
Program
01
SLT Signaling Type
Use this option to tell the system the type of
dialing the connected telephone uses.
For the UNIVERGE SV8100 Wireless
telephones to function correctly, this must be set
to 0 (dial pulse). If this option is set for DTMF,
after an outside call is placed, the system cannot
dial any additional digits.
This program change is automatically performed
when the UNIVERGE SV8100 Wireless
telephone is registered. When upgrading
software from prior versions, the previous default
of 1 is saved from the prior database so this
option must be changed manually.
0=DP
1=DTMF
1 15-03-03
45-01-01
03
Terminal Type
Enter 1 for this option to allow a single line port
to receive DTMF tones after the initial call setup.
Enter 0 to have the port ignore DTMF tones after
the initial call setup. For Voice Mail, always enter
1 (e.g., receive DTMF tones).
0=Normal
1=Special
0 15-03-01
45-01-01
04
Flashing
Enables/disables Flash for single line
telephones.
0=No
1=Yes
1
05
Trunk Polarity Reverse
Do Not Change Default Entry as DTMF issues
may arise with voice mail.
0=Off
1=On
0
To Next Page
Loading...
