UNIVERGE SV8100 Issue 10.1
Programming Manual 2 - 935
Description
(This program is available only via telephone programming and not through PC
Programming).
Use Program 92-04 : Extension Data Swap to swap data between two extensions.
The following table lists Programs that use the Extension Data Swap function.
Program 92 : Copy Program
92-04 : Extension Data Swap
Level:
IN
Input Data
Item
No.
Item Input Data
01
1st Extension Number
Up to eight characters.
02
2nd Extension Number
Program Number Program Name
11-02 Extension Numbering
12-05 Night Mode Group Assignment for Extensions
13-03 Abbreviated Dial Group Assignment for Extensions
13-06 Station Abbreviated Dial Number and Name
15-01 Extension Basic Data Setup
15-02 Multi-Line Telephone Basic Data Setup
15-03 Single Line Telephone Basic Data Setup
15-06 Trunk Access Map for Extension
15-07 Programmable Function Key
15-08 Incoming Virtual Extension Ring Tone Setup
15-09 Virtual Extension Ring Assignment
15-10 Incoming Virtual Extension Ring Tone Order Setup
15-11 Virtual Extension Delayed Ring Assignment
To Next Page
Loading...
